CertoClav Vacuum Pro Serie Bedienungsanleitung Seite 75

Instruction Manual CertoClav Vacuum Pro
Please ensure that the table of installation is strong enough for an autoclave including water and
load weight.
13. Plug in the power cable to the back of the autoclave. Note: Please check if the power input specification on the
nameplate of the autoclave fits the power source specification. Ensure proper grounding. Check if the fuses on
the rear of the autoclave are switched to the upper position. Turn on the autoclave base unit.
14. Connect the COM 4 RS232 cable with the RS232 port on the back of the autoclave.
15. Turn on the touch screen.
16. If the login screen appears after a few seconds, the touchscreen has been connected correctly.
17. If a connection error message appears on the touchscreen, the touchscreen is not able to connect to the
autoclave. Please check to see if the touchscreen has been connected correctly with the COM 4"cable. If the
problem still remains, please perform a factory reset on the touchscreen. Navigate to Settings -> Device->Factory
Reset and confirm the warning dialog.
Jan. 2018
14
Version 7