Safety Instructions; Electrical Connection - AEG BPB331021B Benutzerinformation

4 www.aeg.com
•
•
•
•
•
•
•
•

2. SAFETY INSTRUCTIONS

2.1 Installation
• Remove all the packaging.
• Do not install or use a damaged
• Follow the installation instruction
• Always take care when moving the
• Do not pull the appliance by the
• Keep the minimum distance from the
• Make sure that the appliance is
Downloaded from www.Manualslib.com
Always use oven gloves to remove or put in
accessories or ovenware.
Before carrying out any maintenance, disconnect the
appliance from the power supply.
Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of electric
shock.
Do not use a steam cleaner to clean the appliance.
Do not use harsh abrasive cleaners or sharp metal
scrapers to clean the glass door since they can scratch
the surface, which may result in shattering of the glass.
If the mains power supply cable is damaged, it must
be replaced by the manufacturer, its Authorised
Service Centre or similarly qualified persons to avoid
an electrical hazard.
Excessive spillage must be removed before the
pyrolytic cleaning. Remove all parts from the oven.
To remove the shelf supports first pull the front of the
shelf support and then the rear end away from the
side walls. Install the shelf supports in the opposite
sequence.
WARNING!
Only a qualified person must
install this appliance.
appliance.
supplied with the appliance.
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
handle.
other appliances and units.
installed below and adjacent safe
structures.
manuals search engine
• The sides of the appliance must stay
adjacent to appliances or to units with
the same height.
• The appliance is equipped with an
electric cooling system. It must be
operated with the electric power
supply.

2.2 Electrical connection

WARNING!
Risk of fire and electrical
shock.
• All electrical connections should be
made by a qualified electrician.
• The appliance must be earthed.
• Make sure that the parameters on the
rating plate are compatible with the
electrical ratings of the mains power
supply.