Seav LRX 2218 Handbuch Seite 12

I
MPORTANT NOTES FOR THE INSTALLER
- The control unit was designed to allow the installer to auto-
mate the shutter in accordance with legislation in force. The
installer must comply with safety obligations and minimum re-
quirements.
Installation must be carried out according to EN 60335-2-97
"Specification for safety of household and similar electrical ap-
pliances" part 2 "Particular requirements for drives for rolling
shutters, awnings, blinds and similar equipment"
- The control unit must be connected permanently to the power
supply and it is not equipped with a 230 V a/c electric line sec-
tioning device. The installer is responsible for installing a sec-
tioning device in the system. He should install an omnipolar
switch with category III overvoltage. It must be positioned so
that it is protected against accidental closure.
- For connections (power supply and motors output), use flexi-
ble cables under insulating sheath in harmonised polychloro-
prene H05RN-F with minimum section of the conductors equal
to 1.5 mm2
- Pay attention while making holes in the outside casing,
when passing cables for connection and power supply and as-
sembling the cable glands, that everything is installed in a way
that keeps IP protection characteristics of the panel un-
changed as much as possible.
Pay careful attention when fastening the cables so that they
are anchored in a manner that is stable.
- If two or more control units are to be used, we recommend
you install these at least 3 metres apart to ensure the radio re-
ceiver part works correctly.
- In the aforementioned case of two or more control units, we
recommend you use a single Wireless sensor to avoid radio
interference.
I
MPORTANT NOTE FOR THE USER
- The device must not be used by children or people with any
psychological or physical disability, unless they are supervised
or taught how to use it with care.
- Do not let children play with the device and keep the radio
controls out of their reach.
- ATTENTION: keep this instruction manual and comply with
the important safety instructions inside. Failure to comply with
these instructions could cause damage and serious accidents.
- Inspect the system frequently to check for any signs of dam-
age. Do not use the device if it is in need of repair.
Attention
All operations that require opening the casing (cable connec-
tion, programming, etc.) must be executed during installation by
a qualified technician. Please contact the Technical Assistance
Service should any other work that requires opening the casing
arise (reprogramming, repair or installation changes).
LG2218 – LRS2218 – LRS2218 SET – LRH2218
Conform to the specifications of the RED Directives
2014/53/EU, EMC 2014/30/EU, LVD 2014/35/EU.
12
The products:
Rev. 3.0 13/06/16