Installation - Kratki UMBRELLA Installations- Und Betriebshandbuch

Manufacturer details:
Manufacturer:
Contact details:
European Standard

INSTALLATION

UMBRELLA GAS OUTDOOR HEATER MUST BE INSTALLED AND / OR SERVICED BY A QUALIFIED SPE-
CIALIST. DO NOT ATTEMPT TO MODIFY THE CONSTRUCTION OF THE DEVICE OR ITS COMPONENTS.
ANY MODIFICATION WILL CAUSE IMMEDIATE LOSS OF WARRANTIES AND CERTIFICATES.
PLEASE NOTE: AVOID THE RECOMMENDATIONS OF THESE INSTRUCTIONS WITH REGARD TO
INSTALLATION, OPERATION OR AVOIDING THE RECOMMENDATIONS CONCERNING AUTHORIZED
PARTS AND ACCESSORIES FOR THIS APPLIANCE MAY RESULT IN SERIOUS INJURIES OR DAMAGE
TO PROPERTY.
THIS APPLIANCE HAS BEEN DESIGNED IN ACCORDANCE WITH RESTRICTED SAFETY STANDARDS
AND RECOMMENDED. IT WAS TESTED AND CERTIFIED BY A NOTIFIED BODY ACCORDING TO EN
14543.
GENERAL INFORMATION / IMPORTANT: KEEP THESE INSTRUCTIONS!
It is important to periodically check the proper functioning and integrity of individual components
of the gas control system, as well as structural elements for any damage. It is very important that
the gas control system remains intact and free from any damage. The device can be serviced only
by a qualified technician with appropriate qualifications. Failure to comply with these rules may
result in serious health damage and even death and property damage.
Installation and use must be carried out in accordance with national building regulations. Your
authorized dealer can help you determine what safety precautions should be taken when installing
or using the device. In some cases, you may need to obtain permission to install or operate such a
device. Always consult an authorized dealer or building inspector to determine which regulations
apply to the use and / or installation of the device in your area. In the absence of provisions go-
verning installation and use, it is essential to comply with the instructions in the manual and the
fire safety code.
Do not switch on the device if any of its components has been previously dismantled, damaged
or destroyed. Before reuse, the missing or damaged part must be replaced by the original replace-
ment provided by the manufacturer.
If the device, especially gas control system components or the burner has been flooded, switch off
the device and consult a technical department or a qualified serviceman in order to check whether
the reuse will require replacement of any of the system components.
Kratki.pl Marek Bal
Kratki.pl Marek Bal
ul. Gombrowicza 4, 26-660 Wsola, Polska
tel. +48 48 384 44 88
fax +48 48 384 44 88
www.kratki.com
EN 14543
EN
33