Operation - Kratki UMBRELLA Installations- Und Betriebshandbuch

EN
ATTENTION:
Please note that the gas cylinder while installed inside the appliance has to be fasteneed with a cord
with a carabiners to the bottom brackets as per drawing below:
Fig. 8. An overview of the of the bottom brackets.

OPERATION

The user choosing the gas outdoor heater receives a device equipped with a manual controller. Before
operating the control module, read this manual. Proceedings contrary to the instructions or contrary
to the instructions may result in damage to the gas control system components or the device itself, as
well as to fire, property damage or loss of health.
INSTRUCTIONS FOR MANUAL CONTROL MODULE
Firing up the appliance should follow the instructions below. The manual control system has been
designed to completely eliminate the need for its maintenance and any adjustment. Never attempt to
open or damage the valve or any of its other components in any way.
Firing up the appliance:
1. If you have just connected a gas cylinder to your device, bleed the control lines. Pressing the knob,
turn them counterclockwise until it stops and hold them for a maximum of 5 seconds (the gas will flow
to the pilot burner, but also to the main burner).
2. Continue pressing the knob and turn it back to the starting position and counterclockwise again
until it locks (this activates the pilot burner piezo igniter). Repeat as long as the pilot burner lights up.
(If this operation lasts longer than 30 seconds, wait 5 minutes and try again. If re-lighting does not
cause the pilot burner to fire, contact the service).
3. After the pilot burner has ignited, keep the knob pressed in this position for another 10 seconds until
the pilot burner has ignited.
4. After ignition of the pilot burner, hold the knob in this position for 5 seconds until the thermocouple
warms up, then release the knob and turn it counterclockwise further. You will feel the resistance when
reach the final position – this is the maximum power input and height of the flame available (this will
also start gas flow to the main burner) . Do not try to push it even further!
51