Suntec Wellness KLIMATRONIC DryFix 20 Design Bedienungsanleitung Seite 15

Timer
Off-time:
- Press the TIMER button while the unit is running to determine the off time.
- The time can be set by the hour (0-24h).
On Time:
- Press the TIMER button while the unit is turned off to determine the switch.
- The time can be set by the hour (0-24h).
Auto-dehumidification
- Press the MODE button and select the AUTO dehumidifying mode.
- The unit starts automatically with dehumidification degree of 50%. You can set the desired
dehumidification by operating the HUMIDITY button.
- If the ambient relative humidity is higher than the adjusted dehumidification + 5%, the unit will
run with a higher fan speed.
- If the level ambient relative humidity is in the range of the adjusted dehumidification ± 5%, thus
the device will run with lower fan speed.
- If the level of ambient relative humidity is smaller than the adjusted of dehumidification -5%, the
dehumidifying function will turn off, the device will run with a lower fan speed.
High dehumidification
- Press the MODE button and choose the HIGH DEHUMIDIFYING mode.
- Under this setting, the unit dehumidifies without regarding the ambient relative humidity, the fan
runs faster. This cause the circulation of larger air volume.
Low dehumidification
- Press the MODE button and choose the LOW DEHUMIDIFYING mode.
- Under this setting, the unit dehumidifies without regarding the ambient relative humidity, the fan
runs slower. This cause the circulation of smaller air volume.
Air purifying
- Press the MODE button and choose the FAN mode
- Press the HUMIDITY button to adjust the fan speed
Internal drying
- The unit has an internal dehumidifying function. This allows keeping the unit dry and mould-free,
if it is not used for a long time.
- To activate this function, press and hold the MODE button for at least 2 sec to remove the water
from the device.
- The drying process takes about 45-60 minutes.
- To cancel this process press and hold again the MODE button, the unit will run with the previous
settings. Press the power button to stop the drying process and to put the device into standby
mode.
CONDENSATION WATER DRAINAGE
Water tank:
- When the water tank is full, the corresponding symbol blinks on the display; you can hear the
alarm sound.
- Please turn off the power and unplug the power cord.
- Pull out the water tank carefully, remove the tank lid and tilt the water out.
- Then put the lid back on and slide the water tank carefully into the device.