GET GK-GETBC-0001 Handbuch Seite 8

START OF THE CHARGE
1
2
Pb Lithium
Pb
Lithium
3
START
CHARGING
CHARGING
FULL
Once the battery output conductor cables are connected,
connect the device power cable to the power outlet,
ensuring that the voltage corresponds to the nominal one
of the battery charger
With the battery charger in "stand-by" mode (LED ON
illuminated), select the type of battery to charge by means of
the key "Type of Battery Selector".
Configurable charge parameters
Charge for 12V batteries from 2Ah to 40Ah
Maintenance for 12V batteries from 2Ah to 100Ah
Recommended for Pb batteries: WET – GEL – AGM
Charge for 12V batteries from 2Ah to 40Ah
Maintenance for 12V batteries from 2Ah to 100Ah
Recommended for LiFePO4 lithium batteries.
ATTENTION: do not charge other types of lithium batteries
Press the key START to start the charge.
Charge messages:
Battery status analysis
Battery under charge
The battery is 100% loaded and from now on the battery charger
will go into the maintenance phase and the battery efficiency
status will be constantly monitored, ensuring at the same time
that the battery is always kept at an optimal charge level.
8
EN