Technical Data; Included In Delivery; General Safety Notes - EINHELL VIS 250 Bedienungsanleitung

Anleitung VIS 250 Faust 9-spr
GB
Please read these operating instruc-
tions carefully with particular atten-
tion to the safety notes. Always
store these operating instruccions
together with the vibrating grinder.

Technical data

Voltage
Power consumption
Grinding surface area
Sandpaper size
Vibrations per minute
Shockproof, interference suppressed
Designed in accordance with appli-
cable standards
Included in delivery
VIS 250,
Dust collector bag,
Operating instructions,
3 sheets of sandpaper

General safety notes

– Always remove the plug from the
power supply socket before carrying
out any maintenance or repair work
such as cleaning the sander or
changing the sandpaper!
– Always disconnect the machine by
removing the plug from the socket,
not by pulling on the mains cable.
– Always wear safety goggles and
dust mask when working.
– Keep the workplace clean and well
illuminated.
– Ensure that the workpiece is suffi-
ciently secured so that you are able
to work safety and effectively.
– Keep children away from the
machine.
– Always keep your machine clean,
and check for possible defects of
damage after every job.
– Always ensure that the switch is
switched off before you insert the
plug into the power supply socket.
– Ensure that any platforms you are
working on are sturdy and stable.
– If the machine is damaged, use the
exploded diagram and the spare
parts list to determine the precise
cause of the damage, and order any
neccessary parts from Customer
Service.
8
06.11.2001 9:20 Uhr
230 Volts
170 Watts
227 x 115
280 x 115
20,000
Inserting the dust collector bag or vacuum
Caution!
Health reasons require that you use the
dust collector bag.
Warning!
– The pad sander is not designed
for wet sanding.
– When using a cable reel, make
sure to roll up the cable com-
pletely (wire diameter min.
1 mm 2 ).
– Disconnect the sander from the
power supply when work has
been completed.
– If the machine is defective,
have it serviced by a qualified
dealer immediately.
Seite 8
1 Electrical cord
2 Main grip
3 Locking button
4 On/off trigger
5 Machine identifi-
cation plate
6 Front gripp
7 Dust collector bag
8 Vibration plate
9 Clamping device
10 Sandpaper
On/Off switch
On: Press trigger A.
Continuous Lock trigger A with locking
operation: button B.
Off: Press the operating switch
A briefly and release