Danfoss TP5000 + RF Installationsanweisungen/Inbetriebnahme-Instruktion Seite 10

Running your programme
GB
If you are happy to use the preset programmes on page 8, you
don't need to do anything else.
To accept the presets close the front cover
and after 2 minutes the pre settings will
automatically be accepted (& colon will
blink).
Before you change the preset programmes
Please Note
The unit must be programmed in sequence and ON/OFF
times cannot be programmed out of sequence.
If you want to leave a preset time as it is, simply press PROG
to move on to the next setting.
During programming, if no buttons are pressed for 2 to 3
minutes the unit will automatically return to RUN mode, and
the programme set up to that minute will be active.
!
If at any time you get confused and need to reset the unit to
the preset programmes press the + & – AND
simultaneously.
10
Downloaded from www.Manualslib.com manuals search engine
i2 24
20
& buttons