REEMPLAZAR UN MONITOR WAY
Instalar el monitor adicional Ref.1405/1412 (monitor 1) o Ref.1406/1413 (monitor 2)
Ir a la pantalla MENU & pulsar botón ACERCA DE
Pulsar el botón LLAVE durante 2 segundos
En CONFIGURACIÓN DE INSTALADOR
NOTA: Los monitores extra siempre vienen programados como ESCLAVO de fábrica y
muestran video durante la llamada.
Debe haber siempre un MAESTRO en la vivienda (máximo 1 maestro)
Para
MAESTRO
Para
ESCLAVO
Marcar
o
Marcar
o
Nota Importante: Pilas/Baterías. El equipo contiene una pila botón de litio
CP1120 3V 40Mah soldada al circuito. Esta pila botón debe ser extraída por un
profesional cualificado y depositarla en su punto de recogida selectiva.
REPLACING A WAY MONITOR
Install extra monitor Ref.1405/1412 (monitor 1) or Ref.1406/1413 (monitor 2)
Go to MENU Screen & press ABOUT button
Hold press KEY button for 2 seconds
In the INSTALLER SETUP
NOTE: Extra monitors are always programmed as SLAVE from factory and they show
always video when receiving an incoming call.
There must be always one MASTER in the same house (1 master maximum).
For
MASTER
- Dial
For
SLAVE
- Dial
Dial
8006
o
Dial
8007
o
Important note: Batteries. This equipment contains a lithium button cell CR1120
3V 40mAH welded to the circuit. This button cell must be removed by a qualified
professional and taken to the proper disposal site.
- Marcar
8000
y pulsar OK
- Marcar
8001
y pulsar OK
8006
si queremos tener video+llamada en el monitor ESCLAVO
8007
para no tener video+llamada en el monitor ESCLAVO
8000
and press OK
8001
and press OK
in case you want to have video+call signal in SLAVE monitor
to not have video+call signal in SLAVE monitor
COD. 97833g V06_17