Tristan Auron 8.0 Elite Bedienungsanleitung Seite 21

Water spray button
When you need to activate the water spray function, press the water spray button, the
spray nozzle will spray water mist and wet the clothes that need to be ironed, and
then release the water spray button to stop.
Clean indicator
The appliance needs to be cleaned when the clean indicator lights solidly. And the
clean indicator will blink when the appliance is being cleaned.
Clean button
1. The appliance must be cleaned when the clean indicator lights solidly. Before
perform cleaning, prepare a container with a capacity of more than 300ml for
collecting the waste water, then put the appliance on the container and place the
container steadily.
2. Hold and press the clean button for 2 seconds. When the clean indicator turns off,
if the user needs to perform cleaning, hold and press the clean button for 5 seconds,
then the appliance enters into the cleaning mode and the clean indicator blinks. After
about 3 minutes, the cleaning is completed and the appliance returns to the working
condition.
3. When the clean indicator turns off, if the user needs to perform cleaning, hold and
press the clean button for 5 seconds.When the buzzer sounds, the operator should
remove from the appliance to avoid being burnt by high-temperature steam during the
cleaning process. And the appliance enters into the cleaning mode and the clean
indicator blinks. After about 3 minutes, the cleaning is completed and the appliance
returns to the working condition.
NOTES
(1) For better cleaning, please ensure that the temperature dial be turned to "MAX"
setting
before activate the "Clean" function. The cleaning may be not so good or can not be
performed if the temperature dial is turned to other temperature settings except
20