JANE Transporter Handbuch Seite 24

Not all safety systems are exactly the same, so we advise that you
check your TRANSPORTER in the car in which it is going to be fit-
ted.
It is very important not to use second-hand products, as JANÉ can
only guarantee complete safety with items used by their first buyer.
Never leave the child alone.
RECOMMENDATIONS
Keep this instruction book for future reference. Always store it
in the compartment on the base.
Ensure that inside the car, both luggage and any other object liable
to cause injury in the event of an accident are properly fastened
or stored.
The TRANSPORTER safety seat should be properly fixed with the
safety belts, even when not in use, as in the event of an accident
it may be thrown about, causing injury to the occupants of the
vehicle.
Remember not to use the TRANSPORTER safety seat in cars fitted
with a front airbag, unless it is disconnected or disabled, for which
you should consult the car manufacturer or retailer.
24
MAINTENANCE
Do not expose the cover to sunlight for long periods. When the
seat is not in use, cover it or store it in the boot.
Wash the plastic parts with warm water and soap, carefully drying
all the components afterwards.
The upholstery can be removed for washing. Follow the instruc-
tions below:
• Remove the rubber band that goes underneath one of the car seat belt
fasteners and undo the clasps from the other.
• Also the plastic flaps that are on the sides of the carrycot.
• Remove the upholstery from the edges of your TRANSPORTER carrycot.
• Undo the safety harness clasp and pass it through the slot in the
mattress upholstery.
• Take the upholstery off the backrest and pass the shoulder straps
through the slots.
• Pull the mattress and take the upholstery off by opening the central
part.
Wash by hand at a temperature never higher than 30° C.
To refit the cover, follow the same steps in reverse order.
You can access the link: www.jane.es/seguretat/animatic/
for further information on fitting your new TRANSPORTER.