Installing Your Carrycot In The Car - JANE Transporter Handbuch

Choosing where to install the safety seat
Choosing the correct place for the safety seat in the car can reduce the
risk of injury to your baby in the event of an accident.
The safety carrycot should be installed on the back seat and in a si-
deways position. TRANSPORTER takes up two seats, you can choose
between one side and the central seat, thereby allowing an adult to
travel alongside, or completely centred. If you decide on the side cen-
tral seat, position the TRANSPORTER so that the head part is as far
away as possible from the door.
22
2 Installing your carrycot
in the car
In the reclining position, TRANSPORTER must be fitted cross-wise on
the back seats. Decide on which seats after reading the section on
"Choosing where to install the safety seat".
Fasten the two straps you have chosen, the fasteners are on the
2a -
abdominal part of the belt, this area is marked in light blue in
the diagrams.
2b -
If you have not lowered the backrest to the lying down position,
the incorrect installation safety device will not allow you to insert
the belt into the fastener.
2c - Open the fastener of the belt by turning the lock
2d - Insert the abdominal part of the belt into the fastener and close
the fastener again.
2e -
Lastly, tighten both belts.
To take the TRANSPORTER seat out of the vehicle, open the faste-
2f -
ner of the belt by turning the lock and take the seat belt off.