Kenwood BL710-Serie Bedienungsanleitungen Seite 9

key
blender
filler cap
lid
goblet
sealing ring
blade unit
base
cord storage
speed + pulse control
power unit
vents
mill (if supplied)
mill jar
mill lid
to use your blender
1 Fit the sealing ring
blade unit
is located correctly in the
grooved area.
G
Leaking will occur if the
seal is damaged or
incorrectly fitted.
2 Clip the blade unit
base .
3 Screw the blade assembly onto
the goblet – ensuring the blade
assembly is fully tightened.
Refer to the graphics on the
underside of the blade unit as
follows:
- unlocked position
- locked position
4 Put your ingredients into the
goblet.
5 Fit the filler cap to the lid and
push down to secure.
6 Fit the lid by pushing down until
secure.
7 Place the blender onto the
power unit.
G
The appliance won't work
if the blender is
incorrectly fitted.
8 Plug in and select a speed (refer
to the recommended speed
chart).
G
Select speed 1 (low) to 5 (High)
by turning the speed control. At
the end of blending return the
speed control to "0" before
removing the blender.
into the
- ensuring the seal
into the
G
(P) Pulse – operates the motor
in a start/stop action. The pulse
will operate for as long as it is
held in position.
hints
G
To blend dry ingredients - cut
into pieces, remove the filler
cap, then with the machine
running, drop the pieces down
one by one. Keep your hand
over the opening. For best
results empty regularly.
G
The processing of spices is not
recommended as they may
damage the plastic parts.
G
When making mayonnaise, put
all the ingredients, except the
oil, into the blender. Remove the
filler cap. Then, with the
appliance running, add the oil
slowly through the hole in the
lid.
G
Thick mixtures, e.g. pâtés and
dips, may need scraping down. If
the mixture is difficult to process,
add more liquid.
to use your mill
supplied)
1 Put your ingredients into the jar.
Fill it no more than half full.
2 Fit the sealing ring
blade unit
is located correctly in the
grooved area.
G
Leaking will occur if the
seal is damaged or
incorrectly fitted.
3 Clip the blade unit
base .
4 Turn the mill blade assembly
upside down. Lower it into the
jar , blades down. Turn in a
clockwise direction to lock.
5 Place the mill onto the power
unit.
6 Select a speed or use the pulse
control (refer to the
recommended speed chart).
7 After milling, you can replace the
blade assembly with the mill lid
.
6
(if
into the
- ensuring the seal
into the