Cleaning & Maintenance - ADE M112800 Bedienungsanleitung

tray surface. The tare function is operated as follow: Place the object on the tray surface and press the
TARE button. The additional weight will be subtracted and 0.00 will be shown on the display. A baby
can now be placed on the scale surface and the net weight will appear on the display. The maximum
tare weight must not exceed 500g.
Unit switch function
Press the ON/OFF button twice during the function test. By pressing again the ON/OFF button you
can select the requested units kg or lbs. The kg or lb OZ symbol will appear in the display to indicate
the chosen weighing unit.
Recall of memorized weight
Start the scale via the ON/OFF button and the last measured weight will be displayed for approx.
3 sec. in order to determined weight changes of the infant.
Cleaning instructions
Clean your scale with a soft moist towel or conventional disinfectant only. Do not use any aggressive
cleaning solutions.
Warning signals and error messages
3. Why does the display read 'lo'?
Low battery. Replace the batteries.
4. The message displays 0-Ld
Overload warning; remove the weight immediately; otherwise, permanent damage to the scale will
occur.
Safety instructions
The scale should never get wet. Since this can damage the electronics.
Waste disposal
Electronic devices are not domestic waste.
If the scale is out of use the responsible waste disposal association will be glad to
advise you on the measures necessary to dispose of it properly.
Do not throw used batteries into domestic waste. Please inform yourselves at the
responsible waste disposal association how to dispose used batteries.
Storage and transport
Keep all original parts and pieces for an eventual sending back of the scale in order to avoid any
possible damage during transport which automatically leads to no warranty.
Disconnect all cables before transport to avoid unnecessary damages.
M112800-160118-Rev001-UM-de-e-es-fr-nl
Cleaning & maintenance
15