Marmitek BoomBoom 55 Gebrauchsanleitung Seite 12

6. Put the BoomBoom 55 and your Bluetooth receiver in pairing
mode again.
I am unable to automatically connect to my headphones.
If you no longer automatically establish a connection with your
headphones, press the pairing button twice (the BoomBoom 55
then goes into pairing mode) and put the headset in pairing mode.
I can't pair a second Bluetooth device.
In order to use this feature, both Bluetooth devices should have
Bluetooth version 3.0 or later.
Can I only use the BoomBoom 55 with headphones?
No, you can use the BoomBoom 55 with any Bluetooth device
with audio playback capability. Including, for example, a Bluetooth
speaker or a Marmitek BoomBoom 93 Bluetooth music receiver. If
attached to your audio system, you can choose whether you want
to hear the sound using the audio system and/or your
headphones, or through the TV's speakers.
Whenever I watch TV, audio is out of sync with video.
The wireless transmission of audio over Bluetooth may indeed
result in some delay (latency).
In most cases, this latency is not disturbing.
If you use a media box to watch TV, connect the BoomBoom 55 to
the audio output of your media box. This results in reduced
latency.
The BoomBoom 55 also supports aptX Low Latency technology.
Your Bluetooth headphones also need to have this technology to
be able to use this. With an aptX Low Latency connection, the
LED turns green.
The sound is distorted by a hum or interference
If you do not use an adapter to power the BoomBoom 55, but, for
example, connect it to your audio system's USB connector, the
resulting ground loop may sometimes cause a hum. In this case,
use the USB power adapter. Using a USB port on, for example, a
PC may also cause interference.
Can I pair a Bluetooth device with aptX Low Latency and a
second device without aptX Low Latency?
12 © MARMITEK