En - Operating And Installation Instructions; Functional Description; Electrical Connection - Miele DSM 400 Gebrauchs- Und Montageanweisung

en - Operating and installation instructions

Functional description

The control module enables the
following:
- The cooker hood hob lighting can be
switched on and off via a light switch
integrated in the domestic
installation.
- The potential-free connection is used
to control another appliance
depending on the switch status of
the cooker hood fan.
Installation
Before installation, disconnect the
cooker hood and the components to
be connected from the power
supply.
A position is provided on the cooker
hood for installing the control module.
This position is shown in the images at
the end of these operating instructions.
However, the control module may also
be installed at another suitable location.
Make sure that the control module
housing is earthed. An earthing wire is
provided.
 Remove the cooker hood if this is
necessary to install the control
module. Please observe the
installation instructions supplied with
the cooker hood.
 If the control module will be difficult
to access after installation, connect
the relevant components before
installation (see "Electrical
connection").
12
Ensure that the connection cable and
electrical connections for the
connected components are laid
correctly. They must not be kinked or
crushed.
 Secure the control module with the
screws supplied.
 Insert the connection cable for the
control module into the bushing on
the cooker hood electronic module.

Electrical connection

Wiring diagram
The wiring diagram for connecting the
components can be found at the end of
these operating instructions.
Key:
ZLT.......................................Light switch
PK........................ Potential-free contact
N1 ........ Cooker hood electronic module
N2 .......................... DSM control module
Connecting the light switch
The cooker hood hob lighting can be
switched on and off and dimmed
(depending on the appliance features)
via a light switch integrated in the
domestic installation. The lighting can
also continue to be operated on the
cooker hood.