Information; Displaying Signal Information - Grundig 22 VLE 8220 SG Bedienungsanleitung

INFORMATION

Displaying signal information

(for digital channels only)
1
Open the menu with
»
2
Select the line SOURCE SETUP
»D«
or and press
»
3 Select the line Signal Information
»C« »D«
or and press
– Information on the channel, network,
modulation, symbol rate, quality and
signal strength is displayed.
Notes:
The signal information changes in ac cord-
7
ance with the current input source.
The signal properties are displayed in the
7
lower section of the menu. The further the
»
bars for Quality
extend to the right, the better the reception
signal.
The signal level not only depends on your
7
receiver system, but also on the channel
which is currently active. Remember this
when aligning your antenna based upon
the signal level display.
»M«
4 Press to close the menu.
---------------------------------------------------------------------------------------------------------------------
»M«
.
« »C«
with
» «
OK to confirm.
«
with
» «
OK to confirm.
« »
and Signal Strenght
«
55
ENGLISH