Technical Data - Caframo BDC1850 Bedienungsanleitung

Technical Data

Voltage
Installation Category
(in accordance with IEC664)
Maximum Current Draw
Maximum Output Power
Speed Readout
Speed Readout Accuracy
Torque Readout Accuracy
Maximum Operating Noise
Motor Type
Drive
Hollow drive shaft
Chuck Guard
Seals
Holding chuck
Class
The operating conditions should be monitored at regular intervals.
Page 7
Downloaded from www.Manualslib.com
Protection measures:
Protection device
0 No additional protection
manuals search engine
BDC1850 / 3030 / 6015
120 volts @ 60 Hz 230 volts @ 50/60 Hz
II II
3 Amps 3 Amps
1/5 hp, 150 watts
LCD 4 digit display
+/- 1 rpm or +/- 1% of reading
+/- 12 N-cm (1 in-lb) or +/- 5% of reading
70 dB(A) at 1 meter
Brushless DC
2 stage transmission
Nitrated P .30 with 10 mm (3/8") diameter bore
for stirring impellers
13 mm (0.51") outside diameter for drive chuck
Length 67 mm, (2.64")
Diameter 54 mm, (2.13")
Molded of clear chemical resistant
polyurethane.
Butyl Rubber
IP 42
3 prong stainless steel. Maximum opening
9.5 mm (3/8") diameter
Recommended use
Used only on equipment where failure of the
controls does not represent a hazard.
0