Safety Instructions - Caframo BDC1850 Bedienungsanleitung

Safety Instructions

Page 3
Downloaded from www.Manualslib.com
1. All operators must be familiar with the stirrer and should read this entire
manual.
2. The stirrer must be securely fixed to a stable support. Mount to a Caframo Stand
(Part Number A110) with a Caframo heavy duty clamp (Part Number A120). If
other stands or clamps are used, the unit must be secure and can not fall if tipped
up to ten degrees from the vertical.
3. The stirrer must be supplied with the rated voltage. See serial plate.
4. CAUTION: This is not an explosion proof stirrer. Do not use with highly
flammable or explosive materials.
5. Spinning paddles or impellers can cause severe personal injuries. Operators
must use extreme care and good judgement when mixing at any speed. The
BDC stirrers have higher torque capabilities than conventional stirrers.
6. All mixing paddles and impellers must be in good condition with straight shafts.
If the stirrer vibrates at high speeds check the paddle shaft for damage and repair
or replace it.
7. Extreme care must be taken when mixing chemicals so that no chemicals are
splashed outside the mixing vessel. Care must be taken when changing to faster
mixing speeds. On power up, the unit will display its set speed and will climb
to that speed when the pause button is pushed. Always start at lowest speed if
unsure of maximum safe speed.
8. Ensure that the mixing impeller does not contact the containing vessel.
9. Do not operate while standing in water. Keep the unit dry and do not immerse
any part, except the mixing paddle, into any liquids. Protect from splashing.
10. Ensure that no loose clothing, jewelry, or hair can become entangled in any
rotating parts. Fast spinning chuck can cause injury to operator. Use chuck
guard provided when stirrer is in use.
11. Power can be interrupted to the stirrer by pressing the power button or by
disconnecting the mains cord. If rotating, this will cause the stirrer to stop and
will disconnect power to the stirrer's internal drive circuit.
12. Shaft rotation can also be stopped by pressing the pause button. This does not
disconnect power to the stirrers internal drive circuit.
13. Wear safety goggles and suitable clothing when operating the stirrer.
14. Repairs must be carried out only by technicians authorized by Caframo.
manuals search engine