Deleting The Transmitter - weinor BiEasy 15M Go! Bedienungsanleitung

4.6.5 Deleting the transmitter

Downloaded from www.Manualslib.com
Approaching the lower end position (roller shutter
or awning)
Engage the DOWN button briefly. The blind approaches the
lower end position or the awning retracts completely.
Approaching the lower end position (blind)
Engage the DOWN button until the status display lights
briefly. The blind approaches the lower end position.
Only briefly engage the DOWN button (jog mode with YES
drive, pulse mode with Combio Pulse). The blinds starts
briefly and then stops again.
Approaching the upper end position (roller shutter /
awning)
Engage the UP button briefly. The blind approaches the
upper end position or the awning retracts.
Approaching the upper end position (blind)
Engage the UP button until the status display lights briefly.
The blind approaches the upper end position.
Press the UP button only briefly (jog mode on YES drive,
pulse mode for Combio Pulse), the blind approaches briefly
and stops again.
Deleting the transmitter channel from the receiver
• Engage the STOP button as well as the programming
button P (on the rear of the device).
Keep this button combination pressed for approximately
6 seconds until the status display lights orange briefly and
then lights red.
The channel in the transmitter (or the group) is also deleted.
Ⓒ weinor GmbH & Co. KG
manuals search engine
EN | 79