Synchronised Programming Mode; Stopping Programming Mode In The Transmitter; Approaching The End Position For Roller Shutters; Awnings, Venetian Blinds - weinor BiEasy 15M Go! Bedienungsanleitung

4.6.2 Synchronised programming mode

4.6.3 Stopping programming mode in the transmitter

4.6.4 Approaching the end position for roller shutters,

78 | EN
Downloaded from www.Manualslib.com
For programming one transmitter to multiple receivers at the
same time:
1. Engage the DOWN and the programming P button (rear of
the device) simultaneously (for 3 seconds) on a transmitter
that has already been programmed to the receivers. The
status display flashes. The receivers are now in program-
ming mode.
2. Engage the programming button P on the transmitter
to be programmed until the status display lights briefly.
The receivers are now in programming mode (ascents/
descents).
3. Immediately (no more than 1 second) after the curtain
starts moving upwards, press the UP button. The status
display lights briefly. The curtains stop briefly, start mov-
ing again, stop and then move downwards.
4. Immediately (no more than 1 second) after the curtain
starts moving downwards, press the DOWN button. The
status display lights briefly. The curtains stop moving.
The transmitter is now programmed.
Engage the STOP button for at least 6 seconds until the
status display lights up orange.

awnings, venetian blinds

Requirement:
The transmitter is now programmed. The end positions
are set.
Ⓒ weinor GmbH & Co. KG
manuals search engine