Ferm LMM1012 Originalbetriebsanleitung Seite 11

Technical specifications
Model no.
Voltage
Frequency
Power
No load speed
Cutting width
Cutting height
Grass box capacity
Weight
Protection level
L (sound pressure)
PA
L (sound power)
WA
Vibration value
Vibration level
The vibration emission level stated in this
instruction manual has been measured in
accordance with a standardised test given in
EN60335; it may be used to compare one tool
with another and as a preliminary assessment of
exposure to vibration when using the tool for the
applications mentioned.
- using the tool for different applications, or with
different or poorly maintained accessories,
may significantly increase the exposure level.
- the times when the tool is switched off or when
it is running but not actually doing the job, may
significantly reduce the exposure level.
Protect yourself against the effects of vibration by
maintaining the tool and its accessories, keeping
your hands warm, and organizing your work
patterns.
Description
The numbers in the text refer to the diagrams on
page 2-5.
1. Upper handle
2. On/off switch
3. Safety button
4. Power socket
5. Cable strain relief
6. Cable holder
7. Carrying handle
8. Wheel
9. Wheel cover
10. Grass box basket
11. Grass box lid
12. Grass box cover
13. Grass level indicator
14. Lower handle
LMM1012
15. Knob for handle
230-240 V~
50Hz
1300 W
3. ASSEMBLY
3300/min
320 mm
25/40/55mm
30L
8.1 kg
IPX4
85dB(A) K=3dB(A)
Assembling the lower handle
96dB(A) K=3dB(A)
Fig. A, B, C
<2.5m/s 2 K=1,5ms 2
1. Insert the lower handle (14) into the intended
hole of the lawn mower body, as shown on
figure B. Ensure the hole in the lower handle (14)
aligns with the hole in the lawn mower body.
2. Insert the screw in the hole and tighten by
turning clockwise, as shown on figure C.
3. Repeat these steps for the other lower handle
(14).
Assembling the upper handle
Fig. A, D, E, F
1. Put the cable strain relief (5) on the right side of
the upper handle (1) as shown on figure D.
2. Attach the upper handle (1) to the lower handle
(14), using the supplied bolts and handle
knobs (15) as shown on figure E. Make sure
the on/off switch (2) assembly is on the right
side when standing behind the lawn mower.
3. Fixate the cable to the handle by using the
cable holders (6), as shown on figure F.
Note: When handle knobs (15) are loosened, the
upper handle (1) can be folded down for storing
the lawn mower. Ensure that the power cable is
not caught.
Mounting the wheels
Fig. A, G, H
1. Attach a wheel (8) on the axle. Afterwards, put
a supplied metal washer onto the axle.
2. Insert the supplied metal split pin in the
opening of the axle. Afterwards, fold the metal
split pin around the axle, as shown on figure G.
3. Mount the wheel cover (9) onto the wheel (8).
Make sure the plastic pins on the wheel cover
(9) align with the holes of the wheel (8).
4. Repeat these steps for the other wheels.
Before carrying out any work on the
machine, disconnect the mains plug
from the power supply
11