Operation - cecotec ForceTitanium 520 Bedienungsanleitung

ENGLISH

4. OPERATION

Anti-Calc Function:
The anti-calc function is a permanent system located inside the water tank to eliminate
impurities from the water and reduce the problems derived from limescale build-up. To prolong
the efficiency of this system, follow these steps regularly:
1. Unplug the iron and allow it to cool down.
2. Fill 3/4 of the measuring cup provided with the iron with water. Add 1 teaspoon of salt and fill
the water tank with this solution.
3. Leave the solution in the water tank for 15 minutes, shaking it occasionally, and empty it.
Repeat this step twice.
4. Fill the tank with fresh water to rinse it and empty it.
Anti-Drip Function:
This system controls the water flow to the soleplate at all times. Below a certain temperature,
the anti-drip function cuts off the water flow and prevents the iron from dripping water onto
the fabric.
Auto-Power Off Function:
The iron will automatically turn off if placed in horizontal position for 30 seconds, or in the
vertical position for 8 minutes. To indicate that the iron has been turned off, the unit will beep
6 times and the auto-power off indicator light will blink. The iron can take up to 45-60 minutes
to cool down completely.
To heat up the iron again:
1. Pick up the iron or move it slightly.
2. The auto-power off light indicator will stop blinking.
3. The auto-power off light indicator will remain on and the iron will be ready for use.
ECO mode:
Use this mode for optimal results when steam ironing any type of fabric. This position
guarantees good results saving energy.
Dry ironing:
1. Place the iron in vertical position.
2. Plug the iron.
3. Set the temperature control dial to position 'MIN'.
4. Preheat the iron until the indicator light turns off.
5. The iron is ready for use.
16 FORCETITANIUM 520