Decommissioning, Storage, Disposal; Decommissioning; Storage; Disposal - Mettler Toledo EasyClean100 Bedienungsanleitung

EasyClean100/150

7 Decommissioning, storage, disposal

Procedure
Sorting
EasyClean100/150
52 500 178
Downloaded from www.Manualslib.com
DANGER
Please refer to chapter 2 "Safety".
Decommissioning may only be performed by trained staff or specialists.

7.1 Decommissioning

1. Switch off the power supply, the compressed air supply and the water supply to the device.
2. Disconnect the device from the main unit.
3. Disconnect any signal leads used.
4. Disconnect leads for compressed air.
5. Remove the EasyClean from its mounting.
6. Rinse the hoses and valves with fresh water.
7. Clean the device with a damp cloth.
8. Allow the device to dry.

7.2 Storage

Store the EasyClean in a dry place, as described in section 1.3.

7.3 Disposal

It is recommended that the operator dispose of the device in accordance with local regulations.
The operator must deliver the device to either a licensed private or a public disposal company
or dispose of it himself in accordance with prevailing regulations.
Waste is to be recycled or disposed of without causing any risk to human health and without
using procedures or methods that might damage the environment.
EC guidelines 75/442/EEC
Sorting takes place by placing the device into waste groups as listed in the current European
Waste Catalogue (EWC). This catalogue is valid for all waste, whether it is intended for disposal
or recycling.
The packaging contains the following materials:
– cardboard
– foam plastic
The device contains the following materials:
– steel
– electronic materials (cables, components)
– various components as described in the printed description
– the spray head consists of PVC or PVDF (depending on the version ordered).
manuals search engine
91/156/EEC
© 11/14 Mettler-Toledo AG, CH-8606 Greifensee
31
Printed in Switzerland