Remote Control Handset; Inserting Batteries; Switching On/Off; To Switch The Tv On - AEG ETV4500ZM Bedienungsanleitung

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the batteries from the remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
The battery type used in this product is 2 X 1.5V AAA
or equivalent.
These batteries are located in the remote control and
are readily accessible.
These batteries must be disposed of at your local
collection point.

Switching On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC, 50 Hz.
The standby LED blinks for ten seconds or so, then
lights steadily as the TV enters standby mode.
• To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the " " button, or +/- buttons on the TV.
The TV will then switch on.
Note: If you switch on your TV via standby button on
the remote control, the programme/source that you
were watching last will be reselected.
The standby LED blinks for ten seconds or so until
the screen lights up.

To Switch the TV Off

• Press the " " button on the remote control or hold
the on the TV until shut down, so the TV will switch
to standby mode.
• To power down the TV completely, unplug the power
cord from the mains socket.
Note: When the TV is switched to standby mode, the
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
Digital Teletext
• Press the " " button.
• The digital teletext information appears.
• Operate it with the coloured buttons, cursor buttons
and OK button.
The operation method may differ depending on the
contents of the digital teletext.
Follow the instructions displayed on the digital teletext
screen.
• When the " " button is pressed, the TV returns to
television broadcasting.
• The aspect ratio (picture shape) when watching
a channel with just digital teletext broadcasting is
the same as the aspect ratio of the picture viewed
previously.

Input Selection

Once you have connected external systems to your
TV, you can switch to different input sources. Press
"SOURCE" button on your remote control repeatedly
to change source. Stop pressing when you have the
source you want.
(optional)

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Volume Setting
• Press " " button to decrease volume or "
button to increase volume, so a volume level scale (slider)
will be displayed on the screen.
Programme Selection
• Press " P/CH +" button to select the next programme or
"P/CH -" button to select the previous programme.
- 52 -
"