Makita CF100D Gebrauchsanleitung Seite 8

11. T he contained lithium-ion batteries are subject to the D angerous G ood s L egislation req uirements. F or commercial
transports e.g. by third parties, f orward ing agents, special req uirement on packaging and labeling must be
observ e d . F or preparation of the item being shipped , consulting an ex p ert f or haz a rd ous material is req uired .
P lease also observ e possibly more d etailed national regulations. T ape or mask of f open contacts and pack up the
battery in such a manner that it cannot mov e around in the packaging.
12. F ollow your local regulations relating to d isposal of battery.
:
U se of non-genuine Makita batteries, or batteries that hav e been altered , may result in the battery bursting causing
1. Charge the battery cartrid ge bef ore completely d ischarged . Always stop tool operation and charge the battery
cartrid ge when you notice less tool power.
2. Nev e r recharge a f ully charged battery cartrid ge.
O v e rcharging shortens the battery serv i ce lif e.
3. Charge the battery cartrid ge with room temperature at 10° C– 40° C ( 50° F – 104° F ) . L et a hot battery cartrid ge cool
d own bef ore charging it.
4. Charge the battery cartrid ge if you d o not use it f or a long period ( more than six months) .
Always switch of f the tool bef ore installing or remov i ng of the battery cartrid ge.
T o remov e the battery cartrid ge, slid e it f rom the tool while slid ing the button ( 10) . Make sure to hold the cord less f an
when slid ing out the cartrid ge.
T o install the battery cartrid ge, align the tongue on the battery cartrid ge with the groov e in the housing and slip it into
place. Always insert it all the way until it locks in place with a little click. I f you can see the red ind icator ( 11) on the
upper sid e of the button, it is not locked completely. I nstall it f ully until the red ind icator ( 11) can not be seen. I f not, it
may accid entally f all out of the tool, causing injury to you or someone around you.
.
T o operate the cord less f an using battery cartrid ge, please ref er to the instruction of AC ad aptor.
Only for battery cartridges with the indicator
P ress the check button ( 14) on the battery cartrid ge to ind icate the remaining battery capacity. T he ind icator lamps
( 13) light up f or f ew second s.
I nd icator lamps
L ighted
:
• D epend ing on the cond itions of use and the ambient temperature, the ind ication may d if f er slightly f rom the actual
capacity.
• T he ov e rd ischarge protection f or the battery will work when the battery capacity becomes low. I n this case, cord less
f an stops automatically. I f the cord less f an d oes not operate ev e n when the switch is operated , remov e the battery
f rom the tool and charge the battery.
/
P ush the power switch button ( 1) to turn on the f an. P ush the power switch button again to turn of f the f an.
P ush the speed change button ( 3) while the f an is running. T he wind speed increases ev e ry time you push the
button. T he wind speed will return to the lowest speed when running in the highest speed .
T he cord less f an will start in the same speed as the prev i ous setting.
8
m g .
:
)
)
O f f
) . (
) . (
.
k
. (
.
. (
k g .
R emaining capacity
75% to 100%
50% to 75%
25% to 50%
0% to 25%