Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TS-1 / SL
| commode chair
4. Assembly and adjustments
Your new B+B commode chair is delivered in a B+B original box.
Attached parts are supplied separately to prevent damage during
transport.
You can carry out the adjustments of your commode chair yourself
with a little manual dexterity. If you have any queries, please contact
your specialized dealer.
4.1. Fitting the backrest
•
Push the backrest into the frame tubes on the back, and fix it in
place using the hand screws (see Fig. 02).
•
To remove the backrest, undo the hand screws, unlock the armrests
(see Fig. 03) and pull the backrest up and out of the fixtures.
02
4.2. Arm rests
The armrests can be swivelled downwards in order to allow sideways
transfer and make it easier to use the chair.
03
•
Unlock the armrests by pulling out the pin (see Fig. 03). The
armrests can then be swivelled downwards.
•
When swivelling the armrests upwards, make sure that you hear
them audibly lock into place.
28
Make sure that the tubes are completely plugged
into each other, otherwise the locking can loosen
when leaning against the backrest!
4.3. Foot rests
The footrests can be fitted and removed in just a few steps.
Folding up the foot plates
The foot plates (Fig. 04) can be folded upwards by simply lifting
them. This can be useful when storing the TS-1 in a restricted space.
Foot rest height adjustment
The foot rests can be adjusted in height according to the individual
length of the lower leg of the user.
•
Detach the nut cover
•
Undo the hexagon nut M13 (Fig. 05).
•
Slide the foot rests to the desired position.
•
A suitable height of the foot rests is achieved when the user's
thighs rest flush with the seat with the feet on the foot rests.
•
Re-tighten the hexagon nut and check that the foot rests are
securely in position. Re-attach the nut cover.
•
Repeat the procedure on the opposite side.
Folding away and removing the foot rests
To facilitate getting in and out the commode chair, the foot rests can
be folded away and removed.
•
Undo the locking mechanism.
•
Swing the foot rests outwards.
•
To remove them, first swing the foot rests outwards (Fig. 06); they
can then be pulled up out of their mountings.
•
Follow these instructions in reverse order to fit the foot rests.
Bischoff & Bischoff GmbH | 28.05.2020 - Revision: 1
TS-1 / SL
commode chair |
04
05
06
29
Werbung
Kapitel
Inhaltsverzeichnis
