Jydepejsen DuplicAir Anleitung Seite 13

Replacement/dismantling of temperature sensor
If the chimney is swept from below, it is very important to dismantle the temperature sensor before
sweeping as the temperature sensor can otherwise be damaged.
Dismantling of sensor
1. Remove the top plate.
2. Loosen the set screw (a).
3. Pull out the temperature sensor (b) carefully.
4. Put the stove back together in reverse order after sweeping.
5. The rear flue temperature sensor is dismantled in the same way.
6.
Note! Remember to set the height of the temperature sensor. See section "Temperature Sensor Height" on
the opposite page.