Operating Determinations - EuroLite LED DL-42 Bedienungsanleitung

DANGER TO LIFE!
The electric connection must only be carried out by a qualified electrician!
This device falls under protection-class III. The device always has to be operated with an appropriate
transformer.
The installer must always make sure to connect suitable terminals, connectors and cables!
All valid instructions concerning the electric installation be adhered!
Keep away children and amateurs!

OPERATING DETERMINATIONS

This device is a recessed luminaire for fixed installations. This product is only allowed to be operated with
the voltage given on the type-plate.
This device is rain-proof (IP X3) and therefore qualified for indoor and outdoor use. In order to maintain this
protection grade after opening the housing, any rubber sealings must be examined for damages and always
be correctly installed.
For outdoor use, the installer must always make sure to connect a rubber cable H05R. For installations in the
ground, an underground power cable NYY must be used!
All valid instructions concerning the installation of cables outdoors or in the ground must be adhered!
The ambient temperature must always be between -25° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The maximum relative humidity is 100 % with an ambient temperature of 25° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
The device is only allowed for ceiling or wall installation, but must not be installed in the ground.
This luminaire must never be covered by insulation material, vapour foils or similar building material. Danger
of burning!
Never operate heat-emitting devices (e.g. heating system) next to the installed luminaire. Do not install the
luminaire in the neighbourhood of heat-emitting installations (e.g. heating tubes).
This recessed luminaire must never be installed at furniture.
The F-symbol means: this device can be installed on normal inflammable surfaces.
- - -m
The symbol determines the minimum distance from lighted objects. The minimum distance
between light-output and the illuminated surface must be more than the given value.
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that there are no cables lying around. You endanger
your own and the safety of others!
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported. Make sure that you pack the device in
the original state.
8/10 00029629.DOC, Version 1.2