Operation - Connect IT CEP-9000-BK Benutzerhandbuch

BLUETOOTH EARPHONES
3
Description of Each Part
1. Charging pins
2. Charging magnetic dock for a headphone
3. Battery status indicator
4. Micro USB charging port
5. Red/Blue LED indicator
6. Multifunction button
7. Microphone
4

Operation

Charging the charging case
„ Charge the charging case by means of the supplied Micro USB cable and a USB power adapter with an output of 5 V / max. 2.4 A
(the power adapter is not included, but you can use, for example, a mobile phone adapter or the separately sold original CONNECT IT
adapter of the CWC-2015 series).
„ During charging, there are 1 to 4 LEDs flashing on the charging case, depending on the current charging level of the case.
„ A full charge is indicated by continuous shining of all 4 LEDs.
Charging the headphones
„ To charge the headphones, insert them into the holes of the charging case.
„ During charging, the LEDs on both headphones are flashing in red.
„ A full charge of each headphone is indicated by continuous shining of the LED in red.
Pairing with a phone
1. Switch on the Bluetooth function on the mobile phone and go to the list of discoverable devices (see your mobile phone's manual for
more information).
2. Press and hold the multifunction button on any of the headphones (no matter if right or left) until the LED on the headphone starts
flashing alternately in red and blue. In addition, you will hear the following acoustic responses in the headphone in the order below:
1. „POWER ON"
2. beep
3. „PAIRING"
4. beep
CEP-9000-BK
CEP-9000-WH
1
4
USER MANUAL
EN
2
3
2
5
6
7