Vitek VT-2171 GY Betriebsanweisung Seite 7

• In this case unplug the appliance from
the wall outlet immediately.
• Make sure the rear and front grills are
free, and there is no any foreign object
blocking the air flow.
• Leave the fan heater to cool down for 15-
20 minutes approximately before switch-
ing it on again.
• Connect the appliance to the supply line,
switch it on, and select the power level
and the room heating temperature anew.
• If the fan heater cannot be switched on,
the most probable cause is the fan is
damaged. In this case apply to the serv-
ice center for repair.
Movement detector
This climate control station is equipped
with movement detector (10). It breaks
the electric circuit in case of the appliance
transportation or fall down.
Cleaning and maintenance
To provide the effective operation of the
appliance it is required to change the filters
once per six months of operation.
• Switch the appliance off and unplug from
the wall outlet before cleaning.
• Wipe the outside surface of the appliance
by a soft cloth.
• It is forbidden to use dissolvent and abra-
sive detergents to clean the appliance.
• It is forbidden to immerse the housing of
the appliance into the water or any other
liquids to avoid electric shock.
• Pack the appliance after cleaning, and
store it at a dry place. Do not allow any
sharp object touching the power cord.
• Before switching the appliance on the
next time check its technical state and
the power cord insulation consistency.
Attention: The heater built in this climate
control station is intended for the additional
heating of the room. It cannot be used as
the main heater.
2171.indd 7 2171.indd 7
Specifications
Power supply: AC 220V ~ 50 Hz
Power consumption: 2000 W
Two-position heater switch (1000/2000 W)
Timer: up to 3 hours
Heating/cooling square: up to 25 square
meters
Specifications subject to change without
prior notice.
MINIMUM SERVICE LIFE - 5 YEARS
GUARANTEE
Details regarding guarantee conditions can
be obtained from the dealer from whom
the appliance was purchased. The bill of
sale or receipt must be produced when
making any claim under the terms of this
guarantee.
This product conforms to the
EMC-Requirements as laid
down by the Council Directive
89/336/EEC and to the Law
Voltage Regulation (73/23 EEC)
7
ENGLISH
15.06.2007 11:18:48 15.06.2007 11:18:48