Werbung
Verfügbare Sprachen
Verfügbare Sprachen
ENGLISH
• Insert the plug into the socket, the triple
been signal will be played.
• Press power «ON/OFF» button (11), the
beep sound will be played (in future,
every time you press any button the beep
sound will be played), and all icons will be
flashed on the display for a short time.
The appliance is ready for the operation.
• Press the operating mode (fan cooler/
heater)
selection
HEATER» (12), the icons (17, 18, and 21)
will be lighted on the display. The appli-
ance starts operating in air purifier/fan
heater mode at 1000W power level.
• Press the operating mode (fan cooler/
heater)
selection
HEATER» (12) second time, icon (18)
will be deemed, the heating spiral will be
switched off, and the appliance will oper-
ate in fan cooler/air purifier mode.
• To select the power level (1000 W or
2000W) press power selection button
«HEATER» (13) during the appliance op-
eration. Use «1000 W» power level to
warm up the small rooms, and «2000 W»
power level to heat the large apartments.
The icon (18) indicates the selected pow-
er level.
• Press button «SPEED» (14) to change
the speed of the air flow. There are two
speeds available. The icon (17) indicates
the selected speed.
Setting the timer
Press button «TIMER» (15) on the control
panel to activate the automatic switching
off timer. Every button press prolongs the
timer for 1 hour. Maximum timer value is 3
hours. The timer settings icon (20) will be
lighted on the display. After the set time in-
terval is over, the appliance will be switched
off automatically.
Switching on ionization mode
Press button «-ION» (16) on the control
panel to switch on the ionization mode, the
icon (19) will be lighted on the display.
2171.indd 6
2171.indd 6
button
«COOLER/
button
«COOLER/
6
Notice:
The fan continues rotating for 10-15 sec-
onds after the heating spiral has been
switched off. This is necessary to cool
down the heating spiral.
Trouble shooting
Possible
Problem
causes
1. The ap-
pliance
is un-
plugged
from the
wall out-
let.
2. The sup-
The appli-
ply line is
ance cannot
down.
be switched
3. The ap-
on
pliance
malfunc-
tions.
4. The ap-
pliance is
installed
improper-
ly on the
surface.
1. The filter
is dirty.
High noise
2. The ap-
level
pliance
malfunc-
tions.
Automatic switching off function
The fan heater is equipped with the func-
tion of automatic switching off in case of
overheating.
• If the appliance becomes overheated the
automatic thermal switch snaps into ac-
tion switching off the fan heater.
Elimination
1. Plug the ap-
pliance in.
2. Try to plug
the other
appliance
into the
same sock-
et to test it.
3. Apply to the
authorized
service
center for
repair.
4. The move-
ment de-
tector was
activated.
Install the
appliance
in the verti-
cal position
exactly.
1. Change the
filter.
2. Apply to the
authorized
service
center for
repair.
15.06.2007 11:18:48
15.06.2007 11:18:48
Werbung
