LD Systems LD Stinger Serie Bedienungsanleitung Seite 8

coNTRol ELEmEntS:
1 lINE INpuT
Balanced line input (left/right) XLR/ 6,3 mm jack
(combo).
2
SuB lEVEl
Subwoofer volume.
3 SuB pHaSE
Inverts the phase of the subwoofer (0° / 180°)
if necessary.
4
SuB FREQ
Adjusts the upper cut-off frequency of the
subwoofer (80 - 200 Hz Low-Pass).
5 lINE dIREcT ouTpuT (lEFT/RIGHT)
Balanced XLR line output (left/right).
6 SaT ouTpuT 100Hz (lEFT/RIGHT)
Balanced XLR line output with 100 Hz High-Pass
for active satellites or power amplifiers.
7 poWER lEd
SIGNal lEd
8
Lights up when the unit receives an audio
signal.
9
lIMIT lEd
Lights up when the limiter is active. The limiter
function protects your subwoofer from damage.
If the limiter LED lights up permanently, reduce
volume.
10 pRoTEcT lEd
LED lights up, when the active subwoofer
is overloaded. The subwoofer automatically
switches to mute.
8
11 poWER
Switches power on/off
12 MaINS coNNEcToR (220 - 240 V
ac)
with built in fuse holder (Fuse T 6.3 A
250 V AC)
13 MaINS THRouGH
Supplies units such as active satellites
14 SpEakER ouT
SPKn output for another 8 Ω passive
subwoofer.