Peribit Networks SM-500 Kurzanleitung Seite 6

SM-500 QUICK START
➏
Advertise Local subnet.
By default, a Sequence Mirror's local subnet is not advertised to the other Peribit devices in the community. As a result, data
destined for this subnet is not reduced — even if there is a Peribit device in the path.
• If you want other Peribit devices to reduce data destined for this subnet, select the Advertise checkbox.
• If you choose not to advertise the local subnet, you should review the Reduction Subnets page of the SRS Web console after
completing the Quick Setup.
• In the Device name field, you can assign a name for the Sequence Mirror.
• Click Next to continue.
❼
Enter a license key.
Each Peribit Sequence Mirror requires a unique license key for operation. If the serial number is not shown, you can find the
serial number on the back of the device, and then manually enter it in the Serial Number field.
If you have purchased the SM-500 and have the serial number, you can obtain a permanent license key for the device through
Peribit's Online License Service. The License Key server is accessible by clicking Online Service or by calling Peribit Support
at 1-866-737-4248 (or 408-330-5600).
• Enter the license key for the Sequence Mirror in the License key field.
• Click Next to continue.
❽
Change Administrator password.
• Enter a new Administrator password in the New password and Verify new password fields, and then click Finish.
NOTE: If you deselect the "automatic save" option, configuration settings will be reset upon a power cycle of the Sequence
Mirror.
Where to go next:
Initial configuration is complete and you are now ready to configure policy settings for the Sequence Mirror. Refer to the
Sequence Reducer/Sequence Mirror Operator's Guide, which is located on the Peribit Documentation/Utilities CD. For addi-
tional product support information, visit our Web site at http://www.peribit.com/support.