Quick Setup - Peribit Networks SM-500 Kurzanleitung

SM-500 QUICK START

Quick Setup:

After powering on the Peribit Sequence Mirror and assigning IP parameters, the next step is to log in to the SRS Web console
and run the Quick Setup program. The first time you log in to the Web console, the Quick Setup program starts automatically
and guides you through initial configuration options for the device.
You can log in to the Web console from any workstation in your network. The Web console supports Microsoft Internet
Explorer version 5.5 and 6.0. Data is securely transmitted through HTTPS.
To log in to the Web console and run Quick Setup, follow these steps:
➊
From a workstation in your network, start your Web browser and enter the following URL:
https://(IP address of the Sequence Mirror)
• Depending on your browser settings, the Security Alert dialog box may appear. Click Yes to proceed.
5
• In the Enter Network Password dialog box, type admin for the user name and peribit for the password.
5
NOTE: This is a factory-configured password for the device. You will be asked to change the default password during the
Quick Setup.
➋
Select an Operating Mode.
A Peribit Sequence Mirror can be set up to run in Inline mode or Profile Mode.
• Inline Mode — Active operation where the Sequence Mirror reduces data, accelerates TCP applications, and manages
bandwidth. If you have installed the Sequence Mirror inline (such as between a router and a switch), select this option.
• Profile Mode — Passive operation where the Sequence Mirror can calculate potential data reduction statistics for all
traffic, individual applications, and specific remote subnets. The actual traffic is not affected.
NOTE: To use Profile Mode, the Sequence Mirror's Local interface must be connected to a mirrored port on the switch,
and the Remote interface must be disconnected. If you have installed the Sequence Mirror inline, do not select Profile Mode
as data will be dropped by the Sequence Mirror.
For more information about setting up and using a Sequence Mirror in Profile Mode, refer to "Peribit Profile Mode" in the
Operator's Guide.
• Click Next to continue.