seko POOL BASIC EVO DOUBLE Handbuch Seite 7

Level
OFA First Alarm (time >70%)
OFA Second Alarm (time =100%)
Flow Rate
System Error
Calibration Function
Default parameters:
Language = UK
•
Set Point value= 7,4 pH; 750 mV (Rx)
•
Dosing Method = Acid; Low (Rx)
•
Time OFA = OFF
•
Calibration = Full
•
Flow Input= OFF
•
Type dosing= PROP
•
0000136904
Downloaded from www.Manualslib.com
Alarm
level____7,2_ph
ofa_alarm__7,2_ph
ofa_stop___7,2_ph
Flow_______7,2_ph
Parameter_error
Error_7_ph
Error_4_ph
Error_465_mv
manuals search engine
enter
cal
prog
esc set
Display
Alarm Relay Close
Alarm Relay open
Alarm Relay Close
Alarm Relay open
Alarm Relay Open
Alarm Relay open
To restore Default parameters run Following steps:
Power off Pool Basic unit
•
Keeping Press UP and DOWN Key switch on the
•
Power.
The unit will flash
•
Init.default__Yes
Press up
•
Enter Key to restore Default parameters.
•
rev. 2.0
Relay Actions to do
- Push Enter Key to open
Alarm Relay
- Restore Product tank
- Push Enter Key to reset
- Push Enter Key to reset
- Restore Flow Rate
- Press Enter Key to replace
Default parameter
- Destroy Unit
- Restore Probe or Buffer
solution and repeat calibration
function
Init.default__no
6