Specifications - Kenwood LS-9070ES Bedienungsanleitung

3 Connect the speaker wires to the speaker output terminals of the amplifier.
Using as Front speakers
Right Left
RED WHITE
+
-
R FRONT A L
• When using the speaker as the surround back speaker, connect the speaker wire to the surround back speaker output terminals.

Specifications

System ................. 3 way 6 speakers (Magnetically shielded)
Enclosure ........................ Resonance Acoustic Tube System
Woofer .................................... 80 mm (3") Cone type × 4
Midrange ...................................... 80 mm (3") Cone type
Tweeter ..................................... 19 mm (3/4") Dome type
Nominal Impedance ....................................................... 8 Ω
Peak Input Power ........................................................... 130 W
Sensitivity .................................................. 83 dB / W at 1 m
Frequency Response .................................... 48 Hz~100 kHz
Dimensions
Width .................................................. 220 mm (8-11/16")
Height .............................................. 1,119 mm (44-1/16")
Depth .................................................. 265 mm (10-7/16")
Net Weight ........................................ 10.8 kg (23.8 lb) /piece
Accessories
Speaker wire (10 m (32 ft)) ............................................. 1
Note:
KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without
notice.
4
EN
Wire with white line
Speaker terminals
(Amplifier or AV control center)
Using as Surround speakers
Right Left
SURROUND
GRAY BLUE
+
-
R L
Wire with
white line