Charge Of The Battery - AWELCO THOR 320 Bedienungsanleitung

THOR 320 - 12-24V
Current feed: 230V.
Maximum charging current: 16A – 40A.
Maximum starting current: 300A a 1,5V.
It can start any type of vehicles, vans and little trucks. It can be used also to start big lorries or tractors by effecting a precharge
of 10-15 minutes.
On the control panel we have:
1) Amperometer
2) 12V voltage outlet
3) 24V voltage outlet
4) ON-OFF power switch
5) Charge-Start commutator to choose the charging or the starting of the battery
6) MIN-MAX commutator to choose the charging condition
On the back side of the apparatus we have:
7) Fuse block compartment.

CHARGE OF THE BATTERY

12V
1) Choose the voltage by connecting positive holder into the 12V outlet N.2
2) Connect the red clamp to the (+) (positive terminal) of the battery and the black clamp to a metallic part of the
uninsulated vehicle's body.
3) Connect the primary cable to a socket having on earth connection.
4) Set the switch N.5 into CHARGE position and N.6 into the MIN position.
5) Set the switch N.4 into ON position.
6) You can increase the charging current by setting the commutator N.6 in MAX position.
24V
1) Choose the voltage by connecting positive holder into the 24V outlet N.3
2) Proceed exactly as to charge at 12V.
STARTING
12V
1) Proceed as to charge the battery at 12V by changing the commutator N.5 from CHARGE to START. The booster will
run choosing the right amperage.
2) After having done the starting, disconnect the apparatus from the battery or on the other hand change it over in
CHARGE.
24V
1) Proceed as to charge the battery at 24V by changing the commutator N.5 from CHARGE to START. The booster will
run choosing the right amperage.
2) After having done the starting, disconnect the apparatus from the battery or on the other hand change it over in
CHARGE.
9