Teleco TVRCL868A02F6 Handbuch Seite 8

WARNINGS
IMPORTANT! READ CAREFULLY THIS INSTRUCTIONS BEFORE INSTALLING AND
COMMISSIONING THE PRODUCT. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
PRODUCT INSTALLATION
The product at issue must be installed, commissioned and maintained only by licensed and authorised people, respecting
the laws concerning the electrical installations. Not conforming installations, wrong adjustments or product alterations
may cause fire, electric shock, or personal injuries. The manufacturer is not responsible for any damage due to wrong
installation or improper use.
MOUNTING LOCATION AND MODALITY
The product must be mounted applying the following indications carefully: it must be fixed on surfaces which cannot be
damaged by the high temperature; it must be placed in a well ventilated location; it cannot be hermetically closed; it must
be fixed vertically, with cable glands downward; connection cables must be protected against any accidental impacts,
using proper pipes; do not cover the product; do not use or store flammable materials close to the product.
ELECTRICAL CONNECTIONS
All the connections must be rated for a single-phase 110/230Vac power supply, with the relative Earth connection.
For the disconnection from the power line, use an all-pole switch with contacts having a dimension of at least 3,5mm. Arrange
all the necessary safety devices and use only materials complying with the standard of electrical installations. Signal and
power voltage wiring (110/230Vac) must be separated one from the other. The cable must have a section properly rated
according to the load connected and a nominal temperature range (T) up to 90°C. The following table reports (roughly)
the resistance values and the maximum current of a copper wire, according to its length:
Section (mm2) R (ohm/Km)
1
1.5
2.5
4
6
Attention: If any cable is damaged, it must be immediately replaced by a qualified person in order to avoid any hazard.
SAFETY INFORMATION
This appliance is not intended for use by people (including children) with reduced physical, sensory or mental capabilities, or
not properly informed about the product's characteristics or the possible hazards it can cause. Children should be carefully
supervised when they are in the area of the product. Do not touch the electronic board with wet hands, any metallic or
flammable objects. Do not operate in the high voltage area of the electronic board, when it is supplied. Use the product
only in combination with devices which can guarantee a safe extended time functioning. The radio signal reception of the
device could be disturbed by the presence of electrical disturbances being transmitted by other appliances working on the
same frequency or if the product is somehow shielded by metal parts.
PRODUCT DISPOSAL
At the end of this product's useful life, it must not be disposed of as domestic waste, but must be taken to a collection
centre for waste electrical and electronic equipment. It is the user's responsibility to dispose of this appliance through the
appropriate channels at the end of its useful life. Failure to do so may incur the penalties established by laws governing
waste disposal.
Hereby Teleco automation s.r.l. declares that the product complies with the essential requirements and other relevant
provisions, established by the Directive 1999/5/EC. The declaration of conformity can be consulted on the web site: www.
telecoautomation.com/ce. In the view of a constant development of their products, the manufacturer reserves the
right for changing technical data and features without prior notice.
TECHNICAL SPECIFICATIONS
-Power supply
-Output (cos φ = 1)
-Max. output power
-Dimensions
-IP
Max. current (A)
19.5 5
13.3 10
7.98 16
4.95 26
3.30 32
110-230Vac (28A)
110-230Vac (13A)
3000W (@ 230Vac)
1500W (@ 110Vac)
205 x 145 x 85 mm
54
-Operating temperature range
-Reception frequency
-Radio memory capability
(transmitters)
8
-20° +50°C
868.3 MHz (TVRCL868A02F6)
916 MHz (TVRCL916A02F6)
42