Transmitters Memorization - Teleco TVRCL868A02F6 Handbuch

2 - TRANSMITTERS MEMORIZATION

Before starting select the output L1 or L2, using the switch (see picture at page 5). The following memorization/
deletion will be applied only to the selected output. Anyway it's possible to associate a single or double channel
to both of the output, repating the procedure.
2.1 - MEMORIZATION OF A SINGLE CHANNEL
1- Press once MEM button
and hold it down; the buzzer
will make a beep then sound
continuously.
2.2 - MEMORIZATION OF A DOUBLE CHANNEL (CH1-2, CH3-4, CH6-7) WITH ON/OFF FUNCTION
1- Press two times MEM
button and hold it down the
second time; the buzzer will
make two beeps then sound
continuously.
Note: in case of commanding an output with TIMER function, it's possible to stop the counter before the set
time using buttons CH2, CH4 or CH7.
2.3 - TO COPY A FUNCTION OF A TRANSMITTER TO A NEW TRANSMITTER
Transmitter in the memory
P3
1- Press the button P3 located
inside the already memorized
transmitter. The enabled
receiver sound continuously.
3.1 - TO DELETE A SINGLE/DOUBLE CHANNEL
1- Press once the button
DEL and hold it down; the
buzzer will make a beep
then sound intermittently and
slowly.
3.2 - TO DELETE ALL THE TRANSMITTERS
3.3 - TO DELETE A SINGLE/DOUBLE CHANNEL USING THE TRANSMITTER
Transmitter
in the memory
P3
3X
Transmitter in the memory
2- Within 5 seconds press a button of the
memorized transmitter from which the
function has to be copied. The buzzer will
interrupt the sound for 1 sec. then start
again for 5 seconds.
Press twice the button DEL and hold it down the second time for 10 seconds.
The buzzer will sound intermittently; at the end the buzzer will sound continuously
indicating that the memory has been cancelled.
1- Press three times the button
P3 located inside the transmitter.
The buzzer will sound intermittently
and slowly.
2- During the sound press the button to
memorize; the memorization is indicated
by the intermittent sound of the buzzer.
2- During the sound press the button to
memorize; the memorization is indicated
by the intermittent sound of the buzzer.
2- During the sound press the button to
delete; the deletion is indicated by the
continuous sound of the buzzer.
Transmitter
in the memory
7
New transmitter
3- During the sound press the
button of the new transmitter
to memorize; the memorization
is indicated by the intermittent
sound of the buzzer.
2- During the sound press
the button to delete; the
deletion is indicated by the
continuous sound of the
buzzer.