Herunterladen Inhalt Inhalt Diese Seite drucken

Optional Caster; Maintenance Of The Rotary Hoe; Rotary Hoe Shank - Fort GRUPPO FRESA Gebrauch Und Wartung

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 24
ENGLISH
attachment
rotary hoe
model
dimensions (cm)
A
B
B
B - C
D
D
D
E
D
stands for
tractor
E
stands for
articulated tractor
* All the flange knives are turned inwards.

3.4 OPTIONAL CASTER

Upon request, an additional caster is available to
facilitate the transport operations.
In order to assemble the caster, insert it (4 fig. 3
and 5) in the support.
SECTION 4
Routine Maintenance
We here below describe the maintenance and
adjustment operations. A low operating cost and a
long life of the machine depend also on a methodi-
cal and constant compliance with these instruc-
tions.
The operations of maintenance, adjustment
and preparation for working shall be carried
out when the engine is off and when the ma-
chine is locked.
4.1 MAINTENANCE OF THE ROTARY
HOE
- Stop the engine before any cleaning and main-
tenance operation.
no. of
knives
50
12
50
16
50
16
60
16
50
16
70
20
60
16
80
24
70
20
60
16
24
80
16
80
24
24
80
16
no. of
reductions
flanges
(cm)
4
-
4
37
4
40
50
4
40
4
40
60
6
50
4
50
70
6
60
60
6
50
50
4
40
6
70
4
60
70
6
60
6
70
4
60
- Make sure that all the nuts, screws and bolts
are perfectly tightened, so that the safety condi-
tions are complied with.
- Make sure that the rotary hoe knives have the
right shape.
- Immediately replace the broken knives, if any
(knives, knife supports, coulter)
- Replace the knives before they are worn out.
- After hoeing, wash and clean the rotary hoe and
remove the dirt.
- Periodically check that the nuts for connecting
the attachment are properly tightened.
- Use original spare parts only, for any mainte-
nance and adjustment operation. In this way the
warranty terms will not be declared void and the
technical specifications of the machine will not
be changed.

4.2 ROTARY HOE SHANK

Check the oil level in the rotary hoe shank
periodically. Every 500 working hours change the
oil completely as follows:
- Remove the rotary hoe from the motor hoe.
- Identify the type of gearbox of the rotary hoe by
making reference to the table on page 4.
- Position the rotary hoe with the oil plug «T»
turned face-downwards.
- Remove the oil plug «T» and drain all the used
16
no. of
no. of
knives
flanges
-
-
8
2
8
2
16*
4
8*
2
8*
2
16
4
16*
4
16*
4
24*
6
16
4
16*
4
16*
4
16*
4
8
2
24*
6
16*
4
24*
6
16
4
24*
4
16*
4

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Fort GRUPPO FRESA

Inhaltsverzeichnis