Installation; Mechanical Installation; Electrical Installation - Siemens SiPass Entro Handbuch

Installation

3 Installation
3.1

Mechanical installation

3.2

Electrical installation

10
Building Technologies
Fire Safety & Security Products
The InfoPoint unit has all the connections at the rear and in normal circumstances
you should never need to open the unit.
The InfoPoint can be either surface-mounted or flush-mounted (in a flush-mounting
box BB7 ordered separately). Recommended height may be 140-150 cm. To cater
for disabled persons a suitable height is approximately 90-100 cm.
The InfoPoint is supplied with a wall mount kit as standard. It includes e.g. four
screws of type SecuFast Resitorx 3.5mm to fix the IP811. Please ensure you have
the necessary tools available.
Whether you intend to flush-mount it or not – remember that the cable hole must
allow sufficient clearance for the TCP/IP RJ45-connector. Alternatively the connec-
tor may be mounted on the free end of a Cat-5 cable.
It is important that the InfoPoint is mounted in such a way that light sources are not
reflected in the screen and the viewing angle is optimised for the user.
Mark the position and test mount the unit, but wait with the final mount, until you
have carried on with the further installation and set-up.
Remember that the terminal has an integrated proximity reader and considera-
tions must be taken for electrical noise and disturbances.
The terminal normally only has two connectors – one for the network and one for
the power supply.
The LAN connection (10BaseT) is made through a standard Cat-5 cable to a local
(or global) network with 10Mbit/s.
06.2009