STUWE HYD 12 serie Gebrauchs- Und Bedienungsanleitung Seite 34

7. Dismantling and Re-Installation
5.
6.
7.
34
Increase the oil pressure until the
outer ring automatically slides down
from the inner ring taper.
During this, an oil leak forms
between the outer ring and the
inner ring.
WARNING
The maximum permitted pressure
at the connection "HP" is marked
on the shrink disc.
When the outer ring reaches the support
ring, the connection has been released.
WARNING
Then, immediately switch off the "HP"
high-pressure pump and release
pressure.
Release the oil pump from the
connections "HP" and "T" .
NOTE
Collect any hydraulic oil leakage
coming out of the "Spannen"
(Tighten) connection.