Mounting The Antennas To The Front Of The Quadpack; Daisy-Chaining Two Quadpacks - Sennheiser Quadpack QP 3041 Bedienungsanleitung

¿ »
26
Downloaded from www.Manualslib.com

Mounting the antennas to the front of the Quadpack

If your Quadpacks are to be mounted into a rack or a tower, the antennas
can be connected to the front side by using the GA 3030 AM antenna mount
(see „Accessories" on page 31).
Mount the antenna holders
packs as shown in the diagram on the left. Fasten the antenna holders by
means of the supplied four screws and plain washers to the prepared
holes.
Guide the two cables sideways to the rear of the Quadpacks.
If you wish to mount the two Quadpacks into a rack, fix the two
»
cables
·
"ears"
Connect the two telescopic antennas to the antenna holders
the antennas upwards.
·

Daisy-chaining two Quadpacks

If you daisy-chain two Quadpacks and mount them side by side into a rack,
they can be operated with only one pair of antennas. This pair of antennas
can be connected to the front of the rack as described above.
Connect one antenna or one cable
mount to the BNC socket "ANT. A"
Connect the BNC socket "RF OUT A"
socket "ANT. B"
above.
manuals search engine
¿
to the two outer handles of the two Quad-
of the GA 3030 AM antenna mount to the rack mount
as shown in the diagram on the left.
»
* = to the antennas mounted to the front of the rack.
of the other Quadpack as shown in the diagram
¿
and align
of the GA 3030 AM antenna
of each Quadpack.
of each Quadpack to the BNC