Connecting Headphones; Mounting Two Quadpacks Into A Rack - Sennheiser Quadpack QP 3041 Bedienungsanleitung

Downloaded from www.Manualslib.com

Connecting headphones

For monitoring the audio signals of the mounted receivers, connect a pair of
headphones to the headphone output ¶. The audio signals can be monitored
either separately or simultaneously.
» ¿ ² ¶

Mounting two Quadpacks into a rack

With the rack-mounting kit (see „Accessories" on page 31), two Quadpacks
can be mounted side by side into a 19
¿ » ·
manuals search engine
Turn the headphone volume control
ble.
Connect the headphones to the headphone output ¶.
Press the monitor keys (RX 1 to RX 4)
wish to monitor. The color of the control LEDs
monitor keys changes from red to green.
Slowly turn the headphone volume control
reached the desired volume.
Volume up? – NO!
When people use headphones, they tend to choose a higher volume than
with loudspeakers. Listening at high volume levels for long periods can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.
Place the two Quadpacks side by side onto a table, their bottom sides
facing upwards.
³
Put the mounting plate onto the bottom sides of the Quadpacks and
fix it to the Quadpacks by means of the eight supplied screws.
· ³
Screw the two rack mount "ears"
If you wish to operate the two Quadpacks with a pair of antennas moun-
ted to the front of the rack (see below), fix the two cables
3030 AM antenna mount to the rack mount "ears"
diagram on the left.
"
Mount the system into a 19
²
counter-clockwise as far as possi-
»
next to the receivers that you
¿
below the pressed
²
clockwise until you have
"
rack.
·
to the two connected Quadpacks.
·
as shown in the
rack and screw it tight.
·
»
of the GA
25