Maintenance And Care; General Information; Cleaning The Optics; Taking Out Of Service, Disposal - KLEIBER SC 1 Betriebsanleitung

Store the scanner appropriately in the original packaging. Put a suitable desiccant inside the packing (e.g.
silica-gel) to prevent damage by moisture. Protect the scanner against dust through suitable measures.
The following climatic conditions are required in the storage room of the scanner:
• Temperature range -20 °C . . . +70 °C
• Maximum air humidity to 70 %
• Atmosphere free of dust and corrosive vapors

10 Maintenance and Care

10.1 General information

CAUTION:
Humidity can lead to the destruction of the electrical and electronic components!
Do not use any liquids for cleaning the scanner or cleaning the immediate of the scanner!
IMPORTANT:
The servicing period depends particularly on the operating and environmental conditions and is there-
fore to be specified by the operator!
The scanner is largely maintenance-free. Its function depends, however considerably on the condition of the
optics. The optics must therefore be checked and if necessary cleaned at regular intervals according to the
operating and environmental conditions (see Cleaning the Optics (section 10.2) at page 8). This is necessary
in particular if the measured temperature levels do not lie in the expected range.
In the case of excessive contamination or scratches of the optics, please contact the technical customer service
(contact address see Service address (section 3.3) at page 3).
Check the cables and the housing at regular intervals for damage and a firm seating.

10.2 Cleaning the Optics

Clean the optics with a soft cloth or cotton pad and with white spirits. The optics is thus cleaned and the
scanner is again ready for use.

11 Taking out of service, Disposal

11.1 Taking out of service

DANGER:
Removing electrically live cables risks injury and damage to equipment.
Never remove electrically live connecting cables. Before removing a cable, ensure that the power
supply has been switched off.
Take the scanner out of operation as follows:
1. Switch off the power supply for the scanner.
2. Remove the connection cables.
3. Take the used pyrometer out of operation (as described in the appropriate operation manual).
The scanner is thus out of operation.
SC 1
11 Taking out of service, Disposal
8