ASROCK ALiveN570SLI-eSATA2 Handbuch Seite 19

Downloaded from www.Manualslib.com
2 . 6 2 . 6 2 . 6 2 . 6 2 . 6 Jumpers Setup Jumpers Setup Jumpers Setup Jumpers Setup Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "Short". If no jumper cap
is placed on pins, the jumper is "Open". The
illustration shows a 3-pin jumper whose pin1
and pin2 are "Short" when jumper cap is
placed on these 2 pins.
Jumper
PS2_USB_PW1
(see p.2, No. 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
Clear CMOS Jumper
(CLRCMOS1)
(see p.2, No. 10)
Default
Note: CLRCMOS1 allows you to clear the data in CMOS. The data in CMOS includes
system setup information such as system password, date, time, and system
setup parameters. To clear and reset the system parameters to default setup,
please turn off the computer and unplug the power cord from the power
supply. After waiting for 15 seconds, use a jumper cap to short pin2 and pin3
on CLRCMOS1 for 5 seconds. However, please do not clear the CMOS right
after you update the BIOS. If you need to clear the CMOS when you just finish
updating the BIOS, you must boot up the system first, and then shut it down
before you do the clear-CMOS action.
ASRock ALiveN570SLI-eSATA2
manuals search engine
Short Open
Setting
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.
Clear CMOS
Motherboard
1 9 1 9 1 9
1 9 1 9