ASROCK ConRoe1333-1394 Handbuch Seite 7

Downloaded from www.Manualslib.com
CAUTION!
1. FSB1333-CPU will operate in overclocking mode. Under this situation,
PCIE frequency will also be overclocked to 115MHz.
2. About the setting of "Hyper Threading Technology", please check page 30
of "User Manual" in the support CD.
3. This motherboard supports Untied Overclocking Technology. Please read
"Untied Overclocking Technology" on page 22 for details.
4. This motherboard supports Dual Channel Memory Technology. Before you
implement Dual Channel Memory Technology, make sure to read the
installation guide of memory modules on page 12 for proper installation.
5. There are memory module installation limitations on this motherboard,
please read "Installation of Memory Modules (DIMM)" on page 12 for
details.
6. Please check the table below for the CPU FSB frequency and its corre-
sponding memory support frequency.
CPU FSB Frequency
1333
1066
800
533
* When you use a FSB1333-CPU on this motherboard, it will run at
DDRII500 if you adopt a DDRII533 memory module.
7. Due to the chipset limitation, the actual memory size may be less than
4GB for the reservation for system usage under Windows
XP 64-bit, Windows
8. Although this motherboard offers stepless control, it is not recommended
to perform over-clocking. Frequencies other than the recommended CPU
bus frequencies may cause the instability of the system or damage the
CPU.
9. While CPU overheat is detected, the system will automatically shutdown.
Before you resume the system, please check if the CPU fan on the
motherboard functions properly and unplug the power cord, then plug it
back again. To improve heat dissipation, remember to spray thermal
grease between the CPU and the heatsink when you install the PC system.
10. For microphone input, this motherboard supports both stereo and mono
modes. For audio output, this motherboard supports 2-channel, 4-channel,
6-channel, and 8-channel modes. Please check the table on page 3 for
proper connection.
11. Before installing SATAII hard disk to SATAII connector, please read the "SATAII
Hard Disk Setup Guide" on page 21 to adjust your SATAII hard disk drive to
SATAII mode. You can also connect SATA hard disk to SATAII connector
directly.
12. Power Management for USB 2.0 works fine under Microsoft
Vista TM 64-bit / Vista
ASRock ConRoe1333-1394 Motherboard
manuals search engine
Memory Support Frequency
DDRII533*, DDRII667
DDRII400, DDRII533, DDRII667
DDRII400, DDRII533, DDRII667
DDRII400, DDRII533
®
XP, Windows
® Vista TM and Windows ® Vista TM 64-bit.
TM / XP 64-bit / XP SP1 or SP2 / 2000 SP4.
®
® ®
Windows
7 7 7 7 7