Blaupunkt AFT601 Bedienungsanleitung Seite 7

AFT601
1. Control panel:
1a. On/Off switch button
1b. Speed setting button
1c. Operation mode setting button
1d. Oscillation button
1e. Timer button
ASSEMBLY AND PREPARATION FOR WORK
1. Join the two parts of the base.
2. Place the body on the base, pay attention to the position of the power cord.
3. Screw the base to the body with the fastening screws.
4. Place the device in a convenient place.
USE OF THE TOWER FAN
1. Connect the device to a power source.
2. Start the fan with the switch.
3. Set the expected operating mode with the operating mode setting button:
- Normal mode : the fan will run at the set speed.
- Natural mode : the fan will simulate gusts of wind, cyclically change gusts every 5 seconds from
fastest to smallest speed.
- Night mode : the fan will start at the fastest speed, after 30 minutes it will reduce the speed to
medium, after another 30 minutes to the lowest and will continue to work until it is turned off or the
operating mode is changed.
- Children mode : the fan will set the delayed off mode to 3 hours. The fan will start at the fastest
speed, after 15 minutes will reduce the speed to medium, after another 15 minutes to the lowest.
Oscillation will start automatically, you can turn it off by pressing.
4. The airflow speed can be adjusted with the speed button.
5. With the timer button you can set the delayed switch off function in the range of 1 - 12 hours. Each
press increases the value by 1. To turn off the timer, press the timer button again after setting the
delayed switch off to 12 hours.
6. The oscillation function can be turned on and off with the oscillation button
CLEANING AND MAINTENANCE
Before cleaning and maintenance, make sure that the fan has been disconnected from the power
source.
The fan should be cleaned regularly. Body, posture should be wiped with a dry cloth. The interior
should be blown out with compressed air or vacuumed with a vacuum cleaner.
2. Display
3. Corps
4. Basis
5. Base fixing screw
5
.